12.1 lbs per gallon (1474 grams/liter) @ 68°F
Resist II™ is a fertilizer that is derived from phosphorous acid and potassium hydroxide. This combination is intended to stimulate early growth, root development and resistance to disease.
| Total Phosphoric Acid (P2O5) | . . . . . . |
27.0% |
|
| Soluble Potash (K2O) | . . . . . . |
25.0% |
|
|
Derived from potassium hydroxide and phosphorous acid. |
|||
RESIST II™ contains potassium, which is intended to stimulate root development and resistance to disease.
RESIST II™ is non-phytotoxic when used as directed and is compatible with most commonly used pesticides and fertilizers.
RESIST II™ has a low salt index and can be applied as a foliar or used in drip or micro-sprinkler irrigation systems.
RESIST II™ should not be applied to plants that are stressed by high temperature or lack of moisture.
Phosphorous acid products are intended to be used as a supplemental fertilizer treatment.
* When using RESIST II™ as a foliar application, the phosphite ions are taken up directly by the plant foliage and may undergo a degree of conversion to phosphate ions, or are utilized directly by plants, as phosphite ions. When using RESIST II™ as a soil application on annual crops, you may experience a lesser response from the initial crop, with a corresponding superior response from succeeding crops. In addition, placement close to seeds or root zones may be injurious to crops. The effect may be aggravated by a soil pH below 6.5.
RESIST II™ mixes easily with water as follows:
1. Partially fill tank with water and start agitation.
2. Add pesticides or other nutrients.
3. Add RESIST II™ to circulating tank.
4. Fill tank and agitate thoroughly.
RESIST II™ can be applied to most vegetable and cucurbit crops, field crops, row crops, citrus, fruit and nut trees, vines, olives, turf, nursery and greenhouse plants and ornamental farms.
RESIST II™ may be applied to the soil or used as a foliar and may be applied through center pivot irrigation systems.
SOIL APPLICATION RATES
ALL CROPS: Apply to the soil at 1 quart to 2 quarts per acre. RESIST II™ is most effective with drip or micro-sprinkler irrigation systems. Repeat as needed.
ORNAMENTAL -NURSERY—GREENHOUSE: Apply 1/2 oz to 1 oz per 1000 sq ft. Repeat as needed.
FOLIAR APPLICATION RATES
RESIST II™ may be applied by air or ground spray. Use the appropriate volume of water for the application method and the crop. Apply 1 quart to 2 quarts per acre. Repeat as needed.
Application Precaution: As with all acid materials, user should exercise caution to avoid potential foliar burning. Use caution if applying this product in combination with other materials since mixing could result in a potentially hazardous reaction caused by product incompatibilities. A compatibility test is recommended before tank mixing with other products. The pH of any final spray solution should be checked and the appropriate amount of the solution should be applied to a small area of the intended crop to ensure plant compatibility prior to the application. THE USER ASSUMES FULL RESPONSIBILITY TO ENSURE PRODUCT, EQUIPMENT AND PLANT COMPATIBILITIES.
